What is the specific steps loadometer disassembly
 
很多的公司在完成一項項目以后，地磅都要進行地磅維修搬家，那么地磅就要被拆卸下來，下面就給大家介紹一下地磅搬遷的全過程。
 
Many of the company after the completion of a project, must be loadometer loadometerloadometer repair move, then can be disassembled, here to introduce the whole process ofloadometer relocation.
 
首先要準備好工具，要用到五噸以上的千斤頂一個，還要有螺絲刀，還有24套筒和套筒的扳手，還需要一個相對應的螺絲內六角。先使用活動的扳手把地榜的螺絲打開，然后把每一個蓋板都拆開，在地磅中間位置有一個小的蓋板，然后取出里面的接線盒，打開接線盒以后，然后把傳感器還有主線從接線盒中都拿出來，并且要做好相應的記錄。如果地磅是兩節以上的，那么要把每兩節的傳感器進行拆除，把上面的螺絲擰下來。然后用六角的活動扳手把橫向的螺絲擰開，如果擰的力量不夠可以使用套筒。
 
First of all to ready to use tools, Jack of more than five tons of a, also with a screwdriver, and 24 sleeve and the sleeve wrench, also requires a corresponding screw inner six angle.Wrench to use activity to list the screw to open, and then each cover is opened, there is a small plate in the middle position loadometer, then remove the junction box inside, then open the junction box, and then the sensor and the thread out from the connection box, and to do a good job in the corresponding records. If the scale is more than two, then how should thesensor sections were removed, turn the screw top down. Then use the wrench six angleunscrew the horizontal screw, if not the power of using the socket.
 
最后就是仔細的檢查一遍看看是不是全部的固定件都拆除了，不要破壞原件，否則還得進行地磅維修，收拾好這一些，可以從地磅房中把主線抽出來了。
The last is to carefully check all have a look Is it right? Fixed parts are removed, do not destroy the original, otherwise have to weigh up the repair, some, can put the thread out fromloadometer room.